Low-pressure mercury discharge lamps with a tubular 26 mm envelope
Special protective coating in the lamp-, prevents products from contamination in case of accidental lamp breakage
Easy identification in audit situations by blue ring at one end
Special fluorescent coating gives good colour rendering
Relatively high efficacy, both initially and during lamp lifetime, with high lumen maintenance
Protects products from discolouring and loss of taste by 90% lower UV emission
Compliant with HACCP regulations and supports HACCP certification
Protective coating around the entire lamp
Blue ring around one end
Direct retrofit for all Standard and Super /80 TL-D lamps operating on conventional or HF gear
Highly efficient 3-band fluorescent coating in combination with New Generation pre-coating technology
Available in various colour designations
Low mercury dose
Recyclable at end-of-life, including the protective lamp coating
End-cap has green bottom plate to identify lamp as recyclable
For use where contamination resulting from lamp breakage must be prevented, e.g. in food preparation, health care, pharmaceuticals, cleanrooms etc.
Suitable for use in environments with increased risk of breakage, e.g. sports halls
Suitable for use in environmens where UV emission should be reduced (museums, libraries, archives, food industry, fashion shops, etc.)
Warning & Safety
Not suitable for closed luminaires (as indicated by two blue rings)
Recommended use in combination with self-stopping lamp control system
A lamp breaking is extremely unlikely to have any impact on your health. If a lamp breaks, ventilate the room for 30 minutes and remove the parts, preferably with gloves. Put them in a sealed plastic bag and take it to your local waste facilities for recycling. Do not use a vacuum cleaner.
It’s strongly recommended to replace Secura lamps before or at the moment the specified lamp life (50% failures @ 3 hrs switching cycle) is reached.